CFRNet: Cycle-Consistent Fixed-Point Training for Real-Time Blind Face Restoration on Consumer Embedded NPUs

Blind face restoration on consumer devices has to balance image quality against speed and memory. Strong methods such as GFPGAN and CodeFormer give good perceptual quality, but they rely on large pretrained generative priors and on operators such as attention, codebook lookup, and style modulation that are hard to compile and quantize on the small neural processing units (NPUs) used in consumer hardware. Small convolutional restorers run fast enough, but they tend to over-smooth and to leave artifacts around the eyes, nose, and mouth. We present CFRNet, a 2.0,M-parameter ResNet-style restorer for on-device use at 256×256, the common face-crop size on consumer NPUs. The main idea is Cycle-Consistent Fixed-Point Training (CCFP). Instead of training the network for one pass and then running it several times by hand, we train it to act as a fixed-point operator, so that applying it again to a restored face does not change the face. CCFP uses three training losses, namely progressive multi-cycle supervision, an idempotence loss, and a re-degradation cycle loss, and it adds no cost at inference. To compare fairly under our deployment limits, we retrain all baselines from scratch at the same 256×256 resolution. On a 300-image test set, CFRNet reaches the best perceptual score (LPIPS 0.250 at three cycles, which is 31% lower than one cycle) and also the best PSNR and SSIM at two cycles. It runs in about 23,ms per cycle in INT8 on a HiSilicon Hi3402 NPU, while the same baselines cannot be compiled to that chip. The cycle count k acts as a simple quality knob that needs no retraining: PSNR is best at k!=!2 and LPIPS keeps improving up to k!=!3. We further show that the same idea works with a plain CNN that is even easier to deploy, and we run the model in real time on an in-car driver-monitoring board.